The program itself is now installed under C:\Program Files in 32-bit Windows systems, or C:\Program Files (x86) in 64-bit Windows systems, but none of the files it writes to are stored there. The file structure is changed in N1MM+ as compared with N1MM Logger Classic. See the sections below for information on these.Ĭomments on the Transition from N1MM Logger Classic There are mechanisms to support multiple call signs, multiple hardware configurations, and even multiple Windows user accounts from a single program installation. The program and its installer use Windows Registry entries that only allow for one copy of the program. There should never be more than one copy of the program installed in a single operating system. Setup DX, DXpedition, and General Purpose Contestsĭo not try to install multiple copies of the program.Windows – Table of Contents View (long).Call History and Reverse Call History Lookup.Archive Files (1/2021) – N1MM on WindowsXP.So I imagine the setting are the same, or very similar. Actually, some of the language in setup for the G90 references the IC7000. I also tried the Xiegu G90 setting as well and got the same result. Do you know if there is anything I have to change in the radio like I did with the IC705? I have scoured the internet, and can't find any setting examples. So I am still missing something for the 圆100. And to verify that the app is working (using the latest version), I have been switching radios from the 圆100 to my IC705, and everything works perfectly with the 705 attached. So I feel like I'm almost there, but not quite. However, in the lower right of the spectrum screen, I can see the correct frequency, and when I move the VFO to change frequency, if follows along with the radio. I was able to get my 圆100 to connect using the IC7000 protocol using the following settings: - Speed = 19,200 - Parity = N - Data Bits = 8 - Stop Bits = 1 - DRT = Always On - RTS = Always On - Icom Code (hex) = 70 - Radio Poling Rate = Normal - FootSwitch = None However I still must be missing something because the Spectrum Display is still blank with no visible signal (peaks and valleys) or spots shown with everything connected properly. On Fri, Apr 7, 2023, 3:15 PM David Marotti wrote: Hello Tom.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |